Do you think it is time to teach such neighbours an unforgettable lesson?
For such occasions and more, EMP is your best friend.
Table Of Contents
What is EMP?
This is the same EMP you will be using to put a stop to your obnoxious neighbour.
Disclaimer : Playing with EMPs is dangerous and you may ruin your electronic equipment including medical gadgets and computers.
Using EMP may also be illegal in some countries and we dont condone such actions.
If you agree to above terms, lets get on with building your own EMP gadget.
Bear in mind that the side of the capacitor with the markings represents the negative terminal.
Next, we press the shoot button and immediately remove the batteries to prevent the capacitor from charging again.
Use the voltmeter once again to ensure full discharge.
Step 6: Remove the PCB and replace its charge switchRemove the capacitors PCB and find the on/off button.
The high current momentary switch can easily be procured from the Internet.
Leave the other end unattached for now.
Ensure the wire lines up precisely with no crease or overlap.
Place double-sided tape around the diameter of the circular object to help with this.
Once youve created a satisfactorily thick loop, remove the object.
Now bind the coil with adhesive tape but leave two protruding leads to connect the terminals.
Next, attach the remaining lead to the on side of the switch.
Do not simultaneously hold down the charge button while firing the pulse or you may damage the circuit.
Source: Cameron Cobb viaYouTube
Read More
source: www.techworm.net
